1. Remove all the old strings
2. Make sure to tape down the bridge saddle so it doesn’t move
3. Remove string back plate (if you have one)
4. Start with unpacking the E (lowest) string (and next time around the A and so on…)
5. Check and see if any metal washers are still in the string barrel. If so remove the one on the new string you’re about to install
6. Put the sting through the lowest string slot/barrel
7. Stretch the string past the string post. I use a cable cutter to measure how long the string needs to be before I cut it. I don’t want to have to much excess string around the post. 2-4 turns around the post is the goal.
8. Put the end of the string into the hole in the middle of the string post. Push it down as far as it goes
9. Bend it to the right for the lowest two strings (tuners pointing upwards) and left for the top three strings (tuners pointing downwards
10. Keep turning the tuning peg to get rid of the slack
11. Use a tuner and tune the string up to approx. one whole tone beneath the goal pitch (ex. D for the E-string)
12. Repeat step 4-11 for all the remaining stings
13. Put the string back plate back
14. Tune the strings up to pitch. Come back and retune until they stay in tune. This can take a day of two depending how much you play and stretch the strings
Time to make some new music with a fresh set of strings. Yummy!
Hope this is helpful for your next string changing session!